I recently had to reset an old Craftsman garage door opener and it was a bit of a challenge.

Here’s what I did based from Garage Door Repair Camarillo CA:

First, I located the “Learn” button on the motor unit of the garage door opener. This button was labeled “Learn” and was located near the antenna wire.

Next, I pressed and held down the “Learn” button until the indicator light on the motor unit turned on. This took about six seconds.

Within 30 seconds of pressing the “Learn” button, I pressed and released the “Learn” button again. The indicator light on the motor unit started flashing, indicating that the garage door opener was in programming mode.

To program a new security code, I entered the new four-digit code that I wanted to use on the keypad using the existing keypad. I made sure to use a code that was easy for me to remember but difficult for others to guess.

After entering the new security code, I pressed and held down the “Enter” button on the keypad until the motor unit light flashed once or twice. This indicated that the new security code had been successfully programmed.

To test the new security code, I entered it on the keypad and verified that the garage door opened or closed as expected.

As stated in Garage Door Repair Camarillo CA, if you encounter any issues or the steps don’t work for you, I recommend checking the user manual or contacting the manufacturer’s customer support for further assistance. They may have additional steps or a different reset procedure for your specific model. Additionally, if your old Craftsman garage door opener has a different model than the one discussed here, the reset procedure may be different.

Ventura County Garage Doors & Gate

1943 Yolanda St #8, Camarillo, CA 93010, United States

805-900-4160