Programming a Craftsman Garage Door Repair Houston TX opener is a relatively simple process that can be completed in just a few steps.

Here’s a step-by-step guide on how to program your Craftsman garage door opener:

Step 1: Locate the Programming Button To begin programming your Craftsman garage door opener, you’ll need to locate the programming button. This button is typically located on the back of the motor unit, near the antenna wire. It may be labeled as “learn” or “program.”

Step 2: Clear Out the Opener’s Memory Before you can program your opener, you’ll need to clear out its memory. To do this, press and hold the programming button until the LED light on the motor unit turns off. This typically takes about 6 seconds.

Step 3: Choose a Button on Your Remote Next, you’ll need to choose a button on your remote to program to your opener. Most Craftsman garage door openers can be programmed to work with up to three different remotes or keypad entry systems. For this step, choose a button that you’ll easily remember and can access easily.

Step 4: Press the Programming Button on the Motor Unit Press the programming button on the motor unit once to start the programming process. The LED light on the motor unit will begin flashing, indicating that the opener is in programming mode.

Step 5: Press the Button on Your Remote Next, press the button on your remote that you’ve chosen to program to your opener. The LED light on the motor unit will flash again, indicating that the opener has received the signal from your remote.

Step 6: Test the Opener To ensure that the programming was successful, test your opener by pressing the button on your remote that you programmed. The door should open or close, depending on which button you programmed.

Step 7: Repeat the Process for Additional Remotes If you have additional remotes or keypad entry systems that you’d like to program, simply repeat the process starting from Step 3. You can program up to three different remotes or keypad entry systems.

And that’s it! Programming your Craftsman Garage Door Repair Houston TX opener is a straightforward process that can be completed in just a few minutes. If you run into any issues, consult your opener’s owner’s manual or contact Craftsman customer support for assistance.

First Call Garage Door Southbelt

12373 Scarsdale Blvd suite c, Houston, TX 77089, United States

1-713-547-5170