As a homeowner, I have faced my fair share of garage door problems. From a broken spring to a malfunctioning opener, I know the frustration that comes with a garage door that won’t open or close properly.

In this guide from Garage Door Repair Kansas City, I will share my experience and knowledge on how to fix a garage door.

Before we begin, it’s important to note that garage doors can be dangerous to work on, especially if you don’t have the proper tools or knowledge. If you’re not comfortable working on your garage door, it’s best to call a professional. That being said, let’s get started.

Step 1: Inspect the Door

The first step in fixing a garage door is to inspect it for any obvious signs of damage. Check for broken springs, damaged tracks, worn-out rollers, and loose hardware. If you notice any of these issues, you’ll need to replace the damaged parts.

Step 2: Release the Emergency Release

Before you start working on your garage door, you’ll need to release the emergency release. This will allow you to manually open and close the door without the assistance of the opener. To release the emergency release, locate the red handle on the garage door opener and pull it down.

Step 3: Replace the Springs

If your garage door won’t open or close properly, it’s possible that the springs are broken. To replace the springs, you’ll need to measure the length and diameter of the old springs and purchase new ones that match those measurements. It’s important to replace both springs, even if only one is broken, as they wear out at the same rate.

To replace the springs, follow these steps:

  1. Clamp a locking pliers onto the torsion spring to prevent it from unwinding.
  2. Use a winding bar to unwind the spring from the torsion shaft.
  3. Slide the old spring off the torsion shaft and slide the new spring into place.
  4. Wind the new spring onto the torsion shaft using the winding bar.
  5. Repeat the process for the other spring.

Step 4: Replace the Rollers

If your garage door is making a lot of noise or is difficult to open and close, it’s possible that the rollers are worn out. To replace the rollers, follow these steps:

  1. Open the garage door and secure it in place with clamps.
  2. Remove the old rollers by using a wrench to loosen the bolts that hold them in place.
  3. Slide the old rollers out of the track and slide the new ones into place.
  4. Tighten the bolts to secure the new rollers in place.

Step 5: Lubricate the Moving Parts

To ensure that your garage door operates smoothly, it’s important to lubricate the moving parts on a regular basis. Use a silicone-based lubricant to lubricate the rollers, hinges, tracks, and springs. Avoid using WD-40 or other oil-based lubricants, as they can attract dust and debris.

Step 6: Adjust the Track

If your garage door is crooked or doesn’t close properly, it’s possible that the track is out of alignment. To adjust the track, follow these steps:

  1. Loosen the bolts that hold the track in place.
  2. Use a level to ensure that the track is straight.
  3. Tighten the bolts to secure the track in place.

Step 7: Test the Door

Once you’ve completed all of the above steps from Garage Door Repair Kansas City, it’s time to test your garage door. Use the opener to open and close the door, and check for any issues. If the door operates smoothly and there are no issues, you’re done.

In conclusion, fixing a garage door can be a challenging task, but it’s possible to do it yourself with the right tools and knowledge.

Team Taylor Doors

210 SW Market St Suite 144, Lee’s Summit, MO 64063, United States

816-408-6999